Excavation Safety April 1, 2015
Excavations are common on construction sites in the form of pits, trenches and cuts adjacent to hillsides. Excavations are necessary for construction but can be dangerous. Stiff to hard clays seem very strong and will stand temporarily on vertical cuts for great depths. Clays are, however, deceiving. While the intact strength may be high, failure can occur through joints. Most clays in Central Texas are jointed due to previous desiccation. When the excavation is performed, the relief of lateral restraint causes a strain to take place in the soil matrix concentrated at the joints and cracks. The strain causes these joints and cracks to open slightly and, if moisture is present, a softening effect occurs. Failure of these type of cuts can occur without warning and catastrophically.
Even so called “solid” limestone can be dangerous. I recall seeing photographs of a high profile case in Travis County some years ago wherein a trench was cut through Austin Limestone, an apparently solid formation. However, what was not apparent and could not have been apparent except by the most meticulous investigation in advance, was the presence of steeply sloping fracture planes in the limestone. These were the result of ancient tectonic movements in this formation and it just so happened that they slope toward the trench cut at about 50 degrees from the horizontal. The trench was cut to depths of 5 to 10 feet and, after a weekend of rain, water penetrated the joints and softened them permitting a slip of a large block of limestone into the trench. This block, which weighed many tons happened to catch a worker in the trench with deadly results.
The OSHA regulations of 29CFR 1926.650-.652 published in the Federal Register clearly define procedures and responsibilities for excavation safety. The person doing the excavation has a grave responsibility not only to his employees but also to the general public. Excavations should be analyzed for safety and either sloped back at an appropriate safe angle or be shored properly. Shoring should be placed by workers standing above the excavation and removed from the same level. The widely available aluminum, hydraulically actuated shores are very useful for this. The spacing and type of the shoring depends on the depth and the strength capacity of the soil to be retained and engineering must be applied either by the supplier of the shores or by an independent consultant. Consideration should also be given to cuttings piled adjacent to the edge of the excavation which increases the load on the cut face. Other common sense safety features should be considered such as avoiding material or tools being dropped on the heads of those working below. All excavations should be not only barricaded but fenced from the public including curious kids. Even drilled pier shafts should not be left open without attendance unless properly secured from workers or children falling into these holes.
Proper attention to the results of excavation are important for safety of workers, the general public and property. Property can include contractor’s equipment in an excavation or near a cut face of an excavation, which could be buried or damaged by sudden failure. Property can also include structures established above and near the edge of excavation within a certain distance called the “active zone” or “active wedge”. A sudden slippage or even a slight creep movement can create damage to structures above this area. Proper underpinning and support may be necessary prior to excavation adjacent to existing structures.